net：ipv6：确保我们最多调用一次 ipv6_mc_down()（CVE-2022-48910）
CVE编号
CVE-2022-48910利用情况
暂无补丁情况
N/A披露时间
2024-08-22漏洞描述
In the Linux kernel, the following vulnerability has been resolved: net: ipv6: ensure we call ipv6_mc_down() at most once There are two reasons for addrconf_notify() to be called with NETDEV_DOWN: either the network device is actually going down, or IPv6 was disabled on the interface. If either of them stays down while the other is toggled, we repeatedly call the code for NETDEV_DOWN, including ipv6_mc_down(), while never calling the corresponding ipv6_mc_up() in between. This will cause a new entry in idev->mc_tomb to be allocated for each multicast group the interface is subscribed to, which in turn leaks one struct ifmcaddr6 per nontrivial multicast group the interface is subscribed to. The following reproducer will leak at least $n objects: ip addr add ff2e::4242/32 dev eth0 autojoin sysctl -w net.ipv6.conf.eth0.disable_ipv6=1 for i in $(seq 1 $n); do ip link set up eth0; ip link set down eth0 done Joining groups with IPV6_ADD_MEMBERSHIP (unprivileged) or setting the sysctl net.ipv6.conf.eth0.forwarding to 1 (=> subscribing to ff02::2) can also be used to create a nontrivial idev->mc_list, which will the leak objects with the right up-down-sequence. Based on both sources for NETDEV_DOWN events the interface IPv6 state should be considered: - not ready if the network interface is not ready OR IPv6 is disabled for it - ready if the network interface is ready AND IPv6 is enabled for it The functions ipv6_mc_up() and ipv6_down() should only be run when this state changes. Implement this by remembering when the IPv6 state is ready, and only run ipv6_mc_down() if it actually changed from ready to not ready. The other direction (not ready -> ready) already works correctly, as: - the interface notification triggered codepath for NETDEV_UP / NETDEV_CHANGE returns early if ipv6 is disabled, and - the disable_ipv6=0 triggered codepath skips fully initializing the interface as long as addrconf_link_ready(dev) returns false - calling ipv6_mc_up() repeatedly does not leak anything解决建议
建议您更新当前系统或软件至最新版，完成漏洞的修复。- 攻击路径 N/A
- 攻击复杂度 N/A
- 权限要求 N/A
- 影响范围 N/A
- 用户交互 N/A
- 可用性 N/A
- 保密性 N/A
- 完整性 N/A
| CWE-ID | 漏洞类型 |
Exp相关链接
版权声明
本站原创文章转载请注明文章出处及链接，谢谢合作！
评论